Trimble RTX and Trimble xFill services are undergoing some changes. The frequency and baud rate will change as follows:

Region: Latin America
Name: RTXAL
Frequency: 1545.285 MHz
Baud Rate: 2400 bps

This change must be made before September 30.

 

Instructions for Trimble receivers with RTX capability and Web interface (R2, R10, R10-2, R12, R12i):

 

1. To change the RTX frequency of an R-series receiver (R2, R10, R10-2, R12, R12i), you must connect to its web interface. When the receiver is turned on, it emits a WiFi signal. You will recognize the WiFi access point as it will contain the last digits of your equipment's serial number.

 

2. Connect to this access point and then, in a browser, go to the following address:

The login credentials are as follows:
username: admin
password: password

 

3. If the password "password" does not work, try: STGEO.RI

 

4. Then, go to the MSS Corrections > Configuration menu and verify that the RTX/xFill option is selected. Make sure that the options shown in the image below are the same and then click OK.